HomeMy WebLinkAbout064-210-048L
lnnufti-setsteemarlw
drop-in anchor
Non -bottom bearing. Does not require precise
hole,depth, or hole clean out.
Can he set at any desired depth
• Pre -assembled plug won7t fall out in shipment
• Smaller hole size than other drop -ins,
• Standard inch drill sizes 0;
• Requires less depth than Non -Drill type
• Slotted four ways for uniform ex ansion
P
A SET—TING TOOL IS INCLUDED WITH EACH 100 ANCHORS FREE OF CHARGE
THIS VERSATILE MEDIUM DUTY ANCHOn
CAN BE INSTALLED 3 WAYS.
tilil"
Drill hole any depth.
2. (a) Thread bolt Into
3. Drill hole depth (A)
Flange permits anchor
anchor, (b) Hammer
equal to length of
to be set flush with
anchor Into hole until
anchor, Clean but hole,
surface,
bolt head Is at desIrea
Drop anchor In hole
Anovior c.9n be set at,
height (A). (c) Remove
and set with setting tool,
any desired 1cp1h within
bolt. (d) Sol anchor with
a bottomless hole,
setting tool,
Loa Ijn - -Based on Indepon-
etc,
3 5 0 0 PS Cla %'o'nter " dent Laboratory lesto,
jS. el
LBS. Setting report on P. 21, Tests
Tool conducted In stone
Min. Cat. No. "grogale concrete.
Cat. Bolt DrHI Thread Hole out sh? For manufacturers Sato
Pull
No. SIN Size Depth Depth worklog loads use
lit — 25% of load
MS -14 X4 Y611 2150 1700 T.,4 values,
• S-38 Y, 3300 3450 For Installation In
M MT158
�j Yo '�i 5450 6050 MT -12 sttuctural light weight
• MS -12 1 �4
it
• MS -58 9 Y, 7000 8800 MT -58 concrete use 70%
I - M&34 3/4 1 MA 23/2" 9225 14,500 IAT -34 of the load
L valuos�
non -drilling. anchol Q0
Dependable load capacity due to the same expansion principle
as the Red Head Self -Drilling Anchor.
Easily installed in holes drilled with the 747 Roto Stop Hammer
using Phillips Carbide, Tipped Drill Bits.
A SETTING TOOL IS INCLUDED WITH EACH 100 ANCHORS FREE OF CHARGE,
Load 1, In 'Based on Indepon,
3 P'S.1 dent Laboratory tests,
500 %oncrete, Setting roporl on P. K Tests
LBS, I conducted In stone
I Cat. I Bolt I Drill I Thread I Drilled I Cat. No. aggregate concrete.
M oots or exceeds U,S, Government G�SA Specifications FF -S-326 Group VII I, Type 11 values.
Interim Amendmehl-3 (Doled 4/16/66)
NOTE: Maintain an accurate hole size for proper Installatlo." and Performance. 5