HomeMy WebLinkAboutFAI CF Fire Pump Report CSA 180 12_2019Durhami . PUMP
2313 Durham -Dayton Hwy.
Durham, CA 95938 530.891.4821 CSA #180 - Hawk Ranch
PUMP CHECK REPORT
CUSTOMER NAME: Butte County Fire Dept. DATE: 12/13/2019
Motor Mfg: Franklin HP: 20 Meter #: 22P816
RPM 3450 Volts 460 Phase 3
Rated Amps:
TM 80[—] Yes F]No Serial #
PG &E Acct. # Other:
Panel Mfg: C/H NEMA Size: 3
Type: F—] X/L F—] P/W Other:
Pump Mfg: ? Sub Serial#:
Non -Running Checks: Pump Model Manufacturer
na F—] Lubricant Levels - Service and Change if Necessary Discharge
8" Fab
na 70iler Unit and/or Packing
7 Electrical Leads & Connections - Repair and Tighten as Necessary
Incoming Idle Voltage: F]W/I Acceptable Limits
Unacceptable
F]Fuses - Replace if Necessary 1-1 Replaced Size:
Perform General Clean -Up of Electrical Panel and Motor
Running Checks: Motor winding resistance:
Q's to ground
Excessive or Unusual Noise F]Ok/see comments Pressure tank:
okay
Excessive or Unusual Vibration F]Ok/see comments Tank condition:
Control Devices: FIH.O.A. Start Switch
Time Clock
❑ Frost Start Time Delay Other:
Amperage: Expected: Pressure setting:
Actual: L1: 62.2 L2: 64 L3: 63.1
Average: 63.1
Overload Underload
Even Load
Bowl Adiustment: N/A F1Yes FINo
Comments:
GPS:
The above readings reflect the site and pump conditions at the time of inspection.
This report does not guarantee the continuation of these conditions, nor warranty any part of the existing system.
SAPump Dept. Files\PUMP TESTS & INSPECTIONS\Cal Fire CSA's\180 Hawk Ranch\180 Reports
Durham _il . Pump
2313 Durham -Dayton Hwy.
Durham, CA 95938 530.891.4821
CSA #180 - Hawk Ranch
PUMP CHECK REPORT
CUSTOMER NAME: Butte County Fire Dept. DATE
12/13/2019
Motor Mfg: HP: 1/2 Meter #:
RPM Volts 240 Phase
Rated Amps:
TM 80E—]Yes F—]No Serial #
PG &E Acct. # Other:
Panel Mfg: 2 WIRE SUB NEMA Size:
Type: ❑X/L P/W Other:
Pump Mfg: Serial#:
Non -Running Checks: Pump Model Manufacturer
na FILubricant Levels - Service and Change if Necessary Discharge
na Oiler Unit and/or Packing
Electrical Leads & Connections - Repair and Tighten as Necessary
Incoming Idle Voltage: 1]W/I Acceptable Limits
FlUnacceptable
❑ Fuses - Replace if Necessary ❑ Replaced Size:
❑ Perform General Clean -Up of Electrical Panel and Motor
Running Checks: Motor winding resistance:
Q's to ground
Excessive or Unusual Noise F]Ok/see comments Pressure tank:
Excessive or Unusual Vibration F—]Ok/see comments Tank condition:
Control Devices: FIH.0.A. Start Switch
Time Clock
Frost Start Time Delay Other:
Amperage: Expected: 8.2 Pressure setting:
40-60 psi
Actual: L1: 7.7 7 8.2 L3: 0
Average: 7.95
Overload Underload
Even Load
Bowl Adiustment: N/A Yes FINo
Comments:
GPS:
The above readings reflect the site and pump conditions at the time of inspection.
This report does not guarantee the continuation of these conditions, nor warranty any part of the existing system.
SAPump Dept, Files\PUMP TESTS & INSPECTIONS\Cal Fire CSA's\180 Hawk Ranch\180 Reports