HomeMy WebLinkAboutAttachment B-Grading Permit Application 7-29-2019Butte County Department of Public Works
Butte County Department of Development Services/Planning Division
7 County Center Drive, Oroville, CA 95965 (530) 538-7266 / (530) 538-7601
GRADING PERMIT APPLICATION
INSTRUCTIONS AND INFORMATION
1. It shall be unlawful for any person to commence or perform any grading of more than fifty (50) cubic yards
without first having complied with the conditions and requirements of Butte County Code Chapter 13, Article I.
2. Each application for a permit that is required by this article shall be made by the property owner or his
authorized agent to the Director on this permit application form accompanied by fees as set forth in the Butte
County master fee schedule.
(a) Application review fee - $163 per hour, minimum $700 deposit due at the time of application. The
deposit may be waived if you are pre-approved for an exemption request. If the deposit is waived,
there is a minimum ½-hour charge of $81.50.
(b) Environmental review fee - $163 per hour, minimum $1,630 deposit due when requested.
3. Each application shall include a grading plan prepared and signed by a licensed civil engineer in accordance with
county improvement standards and contain at a minimum the following information:
(a) An accurate location map showing the relation of the project to the nearby community.
(b) An accurate plot plan showing the exterior boundaries of the area affected, and the location of any
buildings.
(c) A description of the work to be done together with the materials to be used thereon, including depth of
fills, height of cuts, proposed spoils location for any excess excavation, and estimated volumes in cubic
yards of excavation and fill.
(d) The location of all drainage to and from the site and the location of culverts and natural watercourses.
(e) A relocation plan for existing waterway or drainage facilities proposed to be altered.
(f) Details of proposed drainage structures.
(g) A description of the methods to be used for erosion and sediment control.
(h) The locations of anticipated stockpile areas.
(i) Other pertinent information, as requested by the Director.
4. An erosion and sediment control plan prepared and signed by a licensed civil engineer conforming to the
standards set forth in Chapter 13, Article I of Butte County Code shall be provided.
5. In certain circumstances in which an environmental review is performed under the control of another regulatory
agency, the Director may approve of an exemption prior to grading as listed in section III of the permit
application. Sufficient information must be submitted to demonstrate that an exemption is warranted.
6. Permit applications may be referred to the Planning Division of the Development Services Department for review
pursuant to the Butte County Environmental Review Guidelines and the California Environmental Quality Act.
7. The Director may submit a report including his recommendations to the Planning Commission together with a
request that the matter be set for public hearing by the Planning Commission.
8. Where it has been determined that the parcel for which the application has been submitted cannot prove that it
was created in conformance with government code, additional documentation shall be provided as requested.
9. Before submitting an application for grading permit, the applicant is requested to discuss with staff all questions
about application requirements, county procedures, zoning provisions and possible conditions of approval.
Grading Permit Application New Logo.doc 2
Butte County Department of Public Works
Butte County Department of Development Services/Planning Division
7 County Center Drive, Oroville, CA 95965 (530) 538-7266 / (530) 538-7601
APPLICATION FOR GRADING PERMIT AND ENVIRONMENTAL REVIEW
SECTION I. GRADING PERMIT INFORMATION
1. Applicant’s Name:
2. Business Phone Number: Home Phone Number:
3. Applicant’s Mailing Address:
4. Applicant’s E-mail Address:
5. Applicant’s Interest in Property: Owner Buyer Lessee Contractor Other
6. Owner’s Name:
7. Owner’s Phone Number:
8. Owner’s Mailing Address:
9. Street Address of Project Site:
10. Assessor’s Parcel Number(s):
11. Acreage of Parcel:
12. Describe location of parcel(s) and attach an accurate location map showing the exterior boundaries of the
area affected, locations of buildings, stockpiles and spoils storage area, drainage, culverts, natural watercourses,
and relocation plan for existing waterways or drainage facilities. Attach details of all proposed drainage
structures and erosion control measures.
13. Description of Proposed Development and Use (Describe the buildings in terms of height, length, width;
describe landscaping use in terms of commercial, residential, recreational and activities associated with the use):
14. Description of Existing Land Use:
Allen Gross
285 Appaloosa Circle, Reno, NV 89508
grossaray@gmail.com
x
Allen Gross
285 Appaloosa Circle, Reno, NV 89508
Pentz Road, southeasterly of intersection with Messilla Valley Road
62.9 acres
The parcel is located off Pentz Road, approximately 1 mile north of the Durham-Pentz Road intersection and just
southeasterly of Messilla Valley Road intersection. Grading is proposed in the westerly portion of the parcel
and will effect approximately 12,800 sf of land . There are no existing structures on the parcel. There is a
roadside ditch that the proposed driveway will cross. A driveway culvert is proposed to direct drainage under
the driveway. See attached grading plan for more information.
The applicant proposes to grade a flat pad area to stage and utilize a recreational vehicle and horse trailer for
personal use. There will also be a driveway connection off Pentz Rd for access to the pad. There are no
proposed permanent building structures associated with this application. The applicant also intends to install a
domestic water well, propane tank and electrical service.
The parcel is currently vacant, undeveloped land. It is zoned AG (agricultural).
(719) 250-3314
(719) 250-3314
041-030-053
Grading Permit Application New Logo.doc 3
15. Proposed Scheduling (Estimate when earthwork will begin: leveling, rough grade work, finish grade work,
etc.):
16. Anticipated Future Development (Are there going to be future roadways, driveways, buildings pads, etc.
developed on the project site after leveling or grading):
17. Describe the work to be done including the equipment and materials to be used:
18. Estimate Total Cubic Yards of Excavation:
19. Estimate Total Cubic Yards of Fill:
20. Estimate Total Cubic Yards of Spoils:
21. Maximum Height of Cuts: Maximum Height of Fills:
22. Maximum and Minimum Slope of Work Site: Cuts (H:V) Maximum Minimum
Fills (H:V) Maximum Minimum
23. Describe Erosion Control Methodology to be Utilized:
24. When the total excavation plus the total fill exceeds 10,000 cubic yards, a detailed engineering plan and
specifications, soil engineering report, and erosion and sediment control plan prepared and signed by a licensed
civil engineer is required when one or more of the following conditions apply:
1. Cuts or fills exceed 15 vertical feet in height.
2. Existing average slope exceeds 20%
The above plans shall be prepared pursuant to the Butte County Code Section 13-8, 13-9, and 13-10. Chapter 13
Article I, “Grading”, is available at http://www.buttecounty.net/publicworks - click on Documents.
September-October 2019
Clearing, ripping, scarifying and mass grading by bulldozer. Fine grading and placement of rip rap and other
erosion control materials by tractor with box grader, backhoe or loader. Compaction of pad by mechanical roller.
AC paving by specialized machinery or by tractor and roller. Application of hydroseed by mechanical
equipment or seeding by hand.
288 cy
222 cy
66 cy
2.6 ft5.4 ft
2:1
2:1
100:1
100:1
Temporary BMP's: placement of stabilized construction entrance to prevent sediment transport onto existing
roadways, installation of straw wattles or silt fencing to prevent concentrated flows and sediment transport along
graded slopes.
Permanent BMP's: preservation of surrounding vegetation, compaction/track walking and hydroseed/seeding of
graded slopes, placement of washed gravel or hyrdorseed/seed of graded pad area, placement of rip-rap or
cobble in drainage ditches.
None
Grading Permit Application New Logo.doc 4
SECTION II. ENVIRONMENTAL REVIEW INFORMATION
1. Describe hazardous materials to be used (inflammable, explosives, strong chemicals, etc.):
2. Daily hours of earthwork:
3. Number of employees on site:
4. List any other related permits and other public approvals required for this project, including those
required by city, regional, State and Federal agencies:
5. Provide the angle of the repose for the given earth material proposed for grading:
6. Identify potentially significant environmental impacts associated with the grading permit:
Gasoline and/or diesel fuels and other conventional engine fluids for construction equipment.
8:00 am - 5:00 pm
2-5 (estimate)
Domestic well permit, permit for propane tank (if
applicable).
Unknown.
None known.
Grading Permit Application New Logo.doc 5
7. Describe project design features or special conditions of approval (mitigation measures) which are
proposed to alleviate potential environmental impacts:
8. Describe the project site as it exists before the project, including information on topography, soil
stability, plants and animals, and any cultural, historical or scenic aspects:
9. Describe the surrounding properties, including information on plants and animals and any cultural,
historical or scenic aspects. Indicate the type of land use, intensity of land use, and scale of development:
Minimal disturbed area, installation of temporary and permanent erosion control measures, preservation of
surrounding vegetation.
The site can generally be described as a rural with rolling hills, grasslands and small oaks, with slopes around
5-10%. There is no observable evidence of unstable slopes, landslides or other significant soil stability issues.
Animal life, cultural, historical or scenic aspects are unknown.
The surrounding properties are rural and similar to the subject parcel. Residential development is low density.
Most surrounding properties are zoned AG or RS with sparse residential development. Animal life, cultural,
historical and scenic aspects are unknown.
Grading Permit Application New Logo.doc 6
SECTION III. EXEMPTION INFORMATION
1. An exemption to the grading permit may be requested if an environmental review is performed under
the control of another regulatory agency. (Check box that applies and provide additional information
to support exemption request)
Excavation and grading authorized by a valid building permit as provided for under appendix J - Grading of the 2007
California Building Code, as adopted by section 26-1 of chapter 26 of the Butte County Code.
Construction of roads for forestry or fire protection purposes, as required by a governmental fire protection agency.
Excavations for: cemetery graves, tunnels, wells, mining, quarrying, under grounding of utilities, public works projects,
archaeological sites, or dams and public refuse disposal sites, controlled by other regulatory agencies.
Emergency projects due to landslides, road and bridge washouts, flooding or other natural disasters.
Routine maintenance of roads or manmade or engineered flood control channels and levees.
Grading, specifically authorized by the terms of any discretionary permit or approval granted by the County of Butte.
Routine Agricultural Grading maintenance to support, keep, replace, refurbish, replant, cultivate and continue in an
existing state or condition without decline, including existing agricultural improvements, such as, but not limited to,
fields, pastures, crops, vineyards, orchards, facilities, buildings, structures, walls, fences, poles, ponds, reservoirs, dams,
pipes, irrigation systems, bridges, and roads. All other agricultural grading for the conversion of existing Non-agricultural
vegetation to an agricultural operation will require an Agricultural Process Grading Review by submission of an
Agricultural Grading Application to the Butte County Agricultural Commissioner for review and approval.
Maintenance of existing firebreaks and roads to keep the firebreak or road substantially in its original condition.
Timber harvest and management activities when approved and carried out consistent with the California Forest
Practices Act.
Clearing of vegetation for fire protection purposes within 100 feet of a dwelling unit. Any additional clearing for fire
prevention, control or suppression purposes is exempt when authorized or required in writing by a fire prevention or
suppression agency.
Construction pursuant to subdivision plans or site improvement plans, which have been approved by the Department of
Public Works. The storage of excess soil from approved projects to be used as fill for other approved projects is exempt
as long as proper erosion and sediment controls are maintained at the stockpiled storage site.
Maintenance of irrigation and drainage facilities.
An excavation for a sewage disposal system or a well that is constructed in accordance with a valid permit issued by the
Butte County Public Health Department, Environmental Health Division.
An excavation for installation, closure, or remediation of an underground storage tank, performed in accordance with a
valid permit issued by the Butte County Public Health Department, Environmental Health Division.
An excavation for removal or remediation of site contamination, performed under the oversight of the Butte County Public
Health Department, Environmental Health Division, or the California Environmental Protection Agency, or the United
States Environmental Protection Agency.
Other – explain on additional sheet of paper.
Grading Permit Application New Logo.doc 7
I hereby declare under penalty of perjury that I have read and understand the instructions and that the
foregoing statements are true, complete and correct to the best of my knowledge and belief.
Contractor Signature Date Owner Signature Date
BUTTE COUNTY DEPARTMENT OF PUBLIC WORKS
THIS SECTION TO BE FILLED OUT BY COUNTY STAFF ONLY
Date Received:
Application Received By:
Total Fees Received: $
Receipt Number:
Grading Permit Approved By:
Grading Permit Number:
APPROVED DENIED
(Date) (Authorizing Signature-Director of Public Works)