HomeMy WebLinkAboutB17-2631_047-280-066_CALFIRE INSPECTION (4)SINCE 1885
41116
Butte County Fire Department
Fire Prevention Bureau
176 Nelson Avenue, Oroville CA 95965
(530) 538-7888 Office, (530) 538-2105 Fax
Permit: B17-2631 APN: 047-280-066
Applicant Name: SECURITY MOBILE HOME SHOW/NORTH INC DBA
Permit Address: 14444 RICHARDSON SPRINGS RD, CHICO, CA 95926
Phone: 530-891-6992 Wendy
Cell:
Under authority of Public Resources Code (PRC) Section 4290 and 4291, Butte County Improvement Standards (BCIS),
California Building Code (CBC), and the California Fire Code (CFC), and Chapter 38A Butte County Code, the following
items are required by CAL FIREButte County Fire Department for all development located within the State and Local
Responsibility Areas of Butte County and are required as part of this permit. These requirements are minimums and may be
superseded by Butte County local regulations exceeding these standards.
This pre inspection is for:
❑ Residence
9 Addition to existing structure
Public Resources Code 4290
ADMINISTRATION
CLl Manufactured Home
0 Ancillary Building (detached garage, shop, shed, etc.)
1272 Maintenance of Defensible Space Measures
To ensure continued maintenance of properties in conformance with these standards and measures and to assure
continued availability, access, and utilization of the defensible space provided for these standards during a wildfire,
provisions for annual maintenance shall be included in the development plans and/or shall be provided as a condition of the
permit, parcel or map approval.
DRIVEWAY STANDARDS
(a1273. Driveways
) All new driveway construction or an extension of an existing driveway shall comply with Public Resources Code
4290 roadway requirements. Driveways can only serve a single parcel.
Length of Driveway
(b) All driveways shall provide a minimum 10 foot traffic lane and unobstructed vertical clearance of 15 feet along its
entire length.
1273.0 Driveway Surface
The surface shall provide unobstructed access to conventional drive vehicles, including sedans and fire engines.
urfaces should be established in conformance with local ordinances, and be capable of supporting a 40,000 pound load. 4"
of class 2 aggregate base shall be required for all driveways, turnouts and turnarounds.
1273 Driveway Grades
The grade for all driveways shall not exceed 15% without being paved. Grades over 15% shall have 4" of class 2
ggregate base and 2" of asphalt concrete. No driveways allowed in excess of 20%.
1274 Driveway Radius
/ (a) No roadway shall have a horizontal inside radius of curvature of less than 50 feet and additional surface width of 4
feet all be added to curves of 50-100 feet radius; 2 feet to those from 100-200 feet.
(b) The length of vertical curves in roadways, exclusive of gutters, ditches, and drainage structures designed to hold or
divert water, shall be not less than 100 feet.
1273,05 Driveway Turnarounds
(d) A turnaround shall be provided to all building sites on driveways over 300 feet in length, and shall be within 50
feet of)he building.
Turnarounds are required on driveways and dead-end roads as specified in this article. The minimum turning radius for
a turnaround shall be 40 feet from the center line of the road. If a hammerhead -T is used, the top of the "T" shall be a
minimum of 60 feet in length.
127 .06 Driveway Turnouts
) Driveways exceeding 150 feet in length, but less than 800 feet in length, shall provide a turnout near the midpoint
of e driveway. Where the driveway exceeds 800 feet, turnouts shall be provided no more than 400 feet apart.
Turnouts shall be a minimum of 10 feet wide and 30 feet long with a minimum 25 foot taper on each end.
3.07 Driveway Structures
(a) All driveway, road, street, and private lane roadway structures (Bridges, culverts, and other appurtenant structures
w ich supplement the roadway bed or shoulders) shall be constructed to carry at least the maximum load and provide the
m imum vertical clearance as required by Vehicle Code Sections 35550, 35750 and 35250. All bridges shall be certified
by a registered Civil Engineer.
(b) Appropriate signing, including but not limited to weight or vertical clearance limitations, one-way road or single
lan • conditions, shall reflect the capability of each bridge.
(c) A bridge with only one traffic lane may be authorized by the local jurisdiction; however, it shall provide for
unobstructed visibility from one end to the other and turnouts at both ends.
GATE STANDARDS
1273 Gate Entrance
(a) Gate entrances shall be at least two feet wider on both ends then the width of the traffic lane(s) serving that gate.
/Minimum 14 foot opening.
(b) All gates providing access from a road to a driveway shall be located at least 30 feet from the roadway and shall
open to allow a vehicle to stop without obstructing traffic on that road.
4...jwhere a one-way road with a single traffic lane provides access to a gated entrance; a 40 foot turning radius shall
be used.
SIGNING AND BUILDING NUMBERING
1274.00. Intent
To facilitate locating an emergency and to avoid delays in response, all newly constructed or approved roads, street, and
buildings shall be designated by names or numbers, posted on signs clearly visible and legible from the roadway. This section
shall not restrict the size of letters of numbers appearing on street signs for other purposes.
ADDRESSING
1274.0. Addresses for Buildings
All buildings shall be issued an address by the local jurisdiction which conforms to that jurisdiction's overall address
system. Accessory buildings will not be required to have a separate address; however, each dwelling unit within a building
shall be separately identified.
1274.p, Size of Letters, Numbers and Symbols for Addresses
Size of letters, numbers and symbols for addresses shall be a minimum 4 inch letter height, 3/8 inch stroke,
reflectorzed, contrasting with the background color of the sign.
1274.10. Installation, Location and Visibility of Addresses
(a) All buildings shall have a permanently posted address, which shall be placed at each driveway entrance and visible
from both directions of travel along the road. In all cases, the address shall be posted at the beginning of construction and
shall be maintained thereafter, and the address shall be visible and legible from the road on which the address is located.
2
Legend: N/A=Not Applicable, X=Required
Revised on 04/10/17
Trakit Copy